![]() ![]()
It have the same size, but is two different disks. I also want to know if the disks must be identical for RAID 0, because mine aren’t :-s. Fisrt is my SSD and second is with the two HDD. In nvidia control panel I see 2 snapping. Fernando S Optimized Nvidia Nforce Driver Packs windows#I have also setup a RAID 0 in bios for other two disks in striped mode, but in windows I see one big HDD NDIVIA JBOD 931,52G, and I don´t know if it is normal or not. I read on some forums that I need to enable RAID mode for SSD. Fernando S Optimized Nvidia Nforce Driver Packs plus#I have an ASUS P5N32-E SLI PLUS with nForce®650i SLI & nForce®570 SLI chipset. I want to tahnk you, you saved my day:).Ģ. Usually I recommend the "Non-AHCI nForce Performance Pack" for nForce4 chipset users.ġ. You will not get AHCI support by any of the nForce driverpacks. This is the only way to get TRIM working within the SSD. Since you will not be able to get AHCI enabled, I recommend to run the SSD in IDE mode by using the generic MS IDE driver named PCIIDE.SYS. Fernando S Optimized Nvidia Nforce Driver Packs how to#You can find a guide about how to get Windows 7 installed onto an nForce4 RAID system within the start post of >this< thread. I am sorry, but your nForce4 chipset system doesn’t support AHCI. So to clarify, could you tell me if I do need to enable the MediaShield RAID mode in my BIOS in order for AHCI to work, if I need to make them part of an array or can I just leave them as JBOD,Īnd what would be the best driver pack (from either yourself or NVIDIA) to get the best performance, stability and AHCI support. Fernando S Optimized Nvidia Nforce Driver Packs install#I am assuming I need to enable RAID mode in the BIOS before I install Windows and install the drivers as well. System drive, but I managed to fix this by disabling RAID mode in the BIOS. After I did this I was unable to boot the I installed the last official WHQL drivers from NVIDIA which are v15.27 for Vista, and proceeded to enable the RAID mode for SATA in the BIOS. Was running in ATA mode so I was not getting NCQ or AHCI at all! I am using Windows 7 Service Pack 1 32-bit. My previous BIOS configuration was not optimal as I had my HDD plugged into the nForce SATA-II port but I had not enabled RAID mode and Windows was using the in-box storage driver which There is no mention of AHCI in my BIOS but there is an option to enable the MediaShield RAID ROM, which I am guessing supports AHCI as part of the MediaShield controller? The ROM is v5.50. I own a DFI LanParty SLI-DR Expert mainboard with the nForce4 SLI AMD (CK804) chipset and I am wondering if it does support AHCI mode and indeed if so I would like to buy an SSD. I have searched the forum for the answers to some questions I have but can’t seem to find them, so here it goes: Hi Fernando! I want to thank you all the hard work you’ve put into this project of yours, it is extremely helpful and your knowledge of storage subsystems is impressive. Good luck and much fun with my driverpacks - any feedback is much appreciated! Nevertheless I have added them for users, which are not satified with the Vista/Win7 in-box Audio Driver. Since Vista/Win7/Win8 have an in-box AC’97 Audio Codec Driver, users probably will not need the Audio Driver of my Special nForce2-4/3-4 LEGACY Driverpacks. WHQL for Win7-10 圆4MIRRORSpecial 32bit nForce RAID Driverpack for Win7-10 x86 v10.8MIRRORSpecial 64bit nForce RAID Driverpack for Win7-10 圆4 v10.8MIRRORSpecial 32bit nForce2-4 LEGACY Driverpack for Win7-10 x86 v10.6MIRRORSpecial 64bit nForce3-4 LEGACY Driverpack for Win7-10 圆4 v10.6MIRRORthisthis< (Win7) thread. WHQL for Win7-10 x86MIRROR64bit Realtek HDAudio Driver v6. That is why I started in January 2008 >thishere32bit nForce4 WHQL Driverpack v9.0 for Vista/Win7/Win8 x86MIRROR64bit nForce4 WHQL Driverpack v9.0 for Vista/Win7/Win8 圆4MIRRORherethisthisHereLatest 32bit nForce Driverpack for Win7-10 x86 v10.8MIRRORLatest 64bit nForce Driverpack for Win7-10 圆4 v10.8MIRROR32bit Realtek AC’97 Codec Audio Driver v63.05 WHQL for Vista/Win7 x86MIRROR64bit Realtek AC’97 Codec Audio Driver v63.05 WHQL for Vista/Win7 圆4MIRROR32bit Realtek HDAudio Driver v6. Some of them are not even usable with certain nForce chipsets. Unfortunately many nForce chipset drivers packages, which have been officially released by NVIDIA, have not been optimized for all nForce chipsets they were designed for. That is why there are no newer nForce chipset driver packs available. ![]() As you probably know, NVIDIA had stopped the development and the production of the nForce chipsets already in springtime 2010.Many users with an nForce chipset mainboard, who are running or going to install Vista, Win7, Win8 or Win10 (32/64bit), are searching for nForce chipset drivers, which are suitable for their special chipset and will give them the best possible performance and stability of their system.All users with a NVIDIA nForce chipset mainboard: ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |